ZyXEL Communications 2864 - Manual (Page 140)

13–2
Password: (Enter supervisor password)
********
Password: (Enter new supervisor password)
********
Verify: (Enter the new supervisor password again)
********
OK
The command AT*Hn will modify the nth user password. You will be prompted to
enter the supervisor password first and then be prompted to enter the nth user pass-
word.
The command AT*V will list the 50 user passwords and the supervisor password
on the screen for viewing. Again, you will be prompted to enter the supervisor pass-
word first.
The commands below will enable different types and levels of security:
For type 2 security, the remote site will be prompted to enter the user password. A
maximum of 3 tries in 40 seconds is allowed. If a correct password is not entered
within this time limit, the line will be disconnected. If the remote site is to enter the
call
-back number, it will be prompted to do so.
Remote Configuration
The 2864 series modems provide a remote configuration capability. Remote config-
uration is provided as a profile by profile batch mode.When on-line, the remote
modem's current configuration or one of its profiles can be read into one of the lo-
cal modem's user profiles. This profile is modified locally and the line can be dis-
connected during this time.
*G0 Disables security function.
*G1 Enables type 1 and level 1 security, with password check.
*G2 Enables type 1 and level 2 security, with password check and
call-back.
*G3 Enables type 2 and level 1 security, with password check.
*G4 Enables type 2 and level 2 security, with password check and
call-back.
*G5 Enables type 2 and level 2 security, with password check and
call-back, remote site enters the call-back number.
Note: Before the security type or level can be changed, the modem re-
quires the supervisor password.