ZyXEL Communications 2864 - Manual (Page 162)

15–8
Class 2 Flow Control
Flow control is necessary to match the DTE-DCE data rate to the line signaling
rate while transmitting or receiving Group 3 (T.4) data. In Class 2 fax mode, both
hardware (RTS/CTS) and software (XON/XOFF) flow control are enabled.
CLASS 2.0 "AT+F" COMMAND SET.
Commands
n=70 Receives the error on phase B hang up code.
n=90 Receives the error on phase C hang up code.
n=100 Receives the error on phase D hang up code.
+FNSC:"
HEX string
" Reports the non-standard facilities command
frame.
+FNSF:"
HEX string
" Reports the non-standard facilities frame re-
sponse.
+FNSS:"
HEX string
" Reports the non-standard setup frame re-
sponse.
+FPOLL Remote polling indication.
+FPTS:n Receive page transfer status response; refer to
+FPTS=n command.
+FTSI:" string " Report remote ID response TSI.
+FVOICE Transition to Voice response.
Command Syntax Description
+= Executes a command or sets a parameter.
+=? Reads permissible settings.
+? Reads the current setting.
Command Value Description
+FAA=n Auto-answer mode parameter:
n=0 The DCE answers as set by +FCLASS.
n=1 The DCE answers and auto-determines the call
type.
+FBO=n Phase C data bit order:
n=0 Selects direct bit order.
n=1 Selects reversed bit order in receiving mode for
phase C data.
+FBS? Buffer size parameter; read only.
Response Value Function and Description