ZyXEL Communications 2864 User Manual
Page 160
15–6
n=2
Error correcting mode is enabled, handled by
the DCE alone, including buffering of partial
pages.
+FET=n
End of page or document command:
n=0
More pages; same document.
n=1
End of document; another document follows.
n=2
No more pages or documents.
n=4
Procedure interrupt; another page follows.
n=5
Procedure interrupt; end of document, another
document follows.
n=6
Procedure interrupt; end of document.
+FK
Regular fax abort command.
+FLID="
string
"
Local ID string parameter.
+FLO=n
Flow control options:
n=0
No flow control.
n=1
Sets XON/XOFF software flow control.
n=2
Sets CTS/RTS hardware flow control.
+FLPL=n
Document for polling command:
n=0
The DTE has no document available for polling.
n=1
Indicates that a document is available for polling.
+FMDL?
Requests the DCE model identification.
+FMFR?
Requests the DCE manufacturer identification.
+FMINSP=n
Minimum phase C speed parameter:
n=0
2400 bps.
n=1
4800 bps.
n=2
7200 bps.
n=3
9600 bps.
n=4
12000 bps.
n=5
14400 bps.
+FPHCTO=
<
value
>
0-255
DTE Phase C response timeout:
Determines how long the DCE will wait for a
command after reaching the end of data when
transmitting in Phase C.
+FPTS=n
Page transfer status:
n=1
Received page is good.
Command
Value
Description