ZyXEL Communications 2864 - Manual (Page 161)

15–7
All other +F commands are not supported, but the modem will respond OK . In
many cases this means "don't care." See PN 2388 for command details.
Class 2 Command Responses
n=2 Page is bad; retrain is requested.
n=3 Page is good; retrain is requested.
n=4 Page is bad; procedure interrupt is requested.
n=5 Page is good; procedure interrupt is requested.
+FREL=n Phase C received EOL alignment:
n=0 The EOL patterns are bit aligned as received.
n=1 The last received bits of EOL patterns are byte
aligned by the DCE, with necessary zero fill bits
inserted. Refer to TIA PN-2388 for details.
+FREV? Requests the DCE revision identification.
+FSPL=n "Enable polling" command:
n=0 Disables polling.
n=1 Enables polling.
Response Value Function and Description
+FCFR Confirmation prompt: ready to receive data.
+FCIG:"
string
" Reports the remote ID response CIG.
+FCON Facsimile connection response.
+FCSI:"
string
" Reports the remote ID response CSI.
+FDCS:vr,br,wd,ln,
df,ec,bf,st Reports the session parameters response; refer
to the +FDCC=.... command.
+FDIS:vr,br,wd,ln,
df,ec,bf,st Reports the session negotiation parameters re-
sponse; refer to the +FDCC=.... command.
+FDTC:vr,br,wd,ln,
df,ec,bf,st Reports the remote capabilities response; refer
to the +FDCC=.... command.
+FET:n Post page message response; refer to the
+FET=n command.
+FHNG:n Call termination status response.
n=00 Normal and proper end of connection.
n=10 Transmits the error on phase A hang up code.
n=20 Transmits the error on phase B hang up code.
n=40 Transmits the error on phase C hang up code.
n=50 Transmits the error on phase D hang up code.
Command Value Description