ZyXEL Communications ES-2108 - Manual (Page 197)

ES-2108 Series User’s Guide
Chapter 30 Troubleshooting 197
C
H A P T E R
30
Troubleshooting
This chapter covers potential problems and possible remedies.
30.1 Problems Starting Up the Switch
30.2 Problems Accessing the Switch
Table 61 Troubleshooting the Start-Up of Your Switch
PROBLEM CORRECTIVE ACTION
None of the LEDs
turn on when you
turn on the switch.
Check the power connection and make sure the power source is turned on.
If the error persists, you may have a hardware problem. In this case, you should
contact your vendor.
Table 62 Troubleshooting Accessing the Switch
PROBLEM CORRECTIVE ACTION
I cannot
access the
switch using
Telnet.
Make sure the ports are properly connected.
You may have exceeded the maximum number of concurrent Telnet sessions. Close
other Telnet session(s) or try connecting again later.
Check that you have enabled Telnet service access. If you have configured a secured
client IP address, your computer’s IP address must match it. Refer to the chapter on
access control for details.
I cannot
access the
web
configurator.
The administrator username is “admin”. The default administrator password is “1234”.
The username and password are case-sensitive. Make sure that you enter the correct
password and username using the proper casing. If you have changed the password
and have now forgotten it, you will need to upload the default configuration file. This
restores all of the factory defaults including the password.
Check that you have enabled web service access. If you have configured a secured
client IP address, your computer’s IP address must match it. Refer to the chapter on
access control for details.
Your computer’s and the switch’s IP addresses must be on the same subnet.
See the following section to check that pop-up windows, JavaScripts and Java
permissions are allowed.