ZyXEL Communications ES-2108 - Manual (Page 185)

ES-2108 Series User’s Guide
Chapter 28 Command Examples 185
Figure 125 egress set Command Example
28.10.8 qos priority
Syntax:
qos priority <0 .. 7>
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the IEEE 802.1p quality of service priority as four (4).
Figure 126 qos priority Command Example
28.10.9 name
Syntax:
name
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set a name for the ports.
ras(config)# vlan-type port-based
ras(config)# interface port-channel 1,3-5
ras(config-interface)# egress set 0,7-9
<0 .. 7> Sets the quality of service priority for a port.
ras(config)# interface port-channel 1,3-5
ras(config-interface)# qos priority 4
Sets a name for your port interface(s).