ZyXEL Communications ES-2108 - Manual (Page 166)

ES-2108 Series User’s Guide
166 Chapter 27 Introducing the Commands
27.9.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
lacp Enables LACP for a trunk
group.
interface
list> timeout
Defines the port number and
LACP timeout period.
vlan <1-4094> Enters the VLAN configuration
mode. See Section 27.9.5 on
page 168 for more information.
vlan-type <802.1q|port-based> Specifies the VLAN type.
vlan1q gvrp Enables GVRP.
ingress-check Enables VLAN tag checking on
incoming traffic.
port-isolation Enables port-isolation.
wrr Sets the switch to use Weighted
Round Robin queuing (WRR).
Sets the WRR weight. A weight
value of one to eight is given to
each variable from wt1 to wt4 .
Table 58 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION
Table 59 interface port-channel Commands
COMMAND DESCRIPTION
interface
port-channel
Enables a port or a list of ports
for configuration.
bandwidth-limit Enables bandwidth control on
the port(s).
egress Sets the maximum bandwidth
allowed for outgoing traffic on
the port(s).
ingress Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
bmstorm-limit Enables broadcast storm
control on the port.
Sets the limit of broadcast storm
packets in kilobit per second
(Kbps).
diffserv Enables DiffServ on the port(s).
egress set
list>
Sets the outgoing traffic port list
for a port-based VLAN.