ZyXEL Communications ES-2108 - Manual (Page 152)

ES-2108 Series User’s Guide
152 Chapter 27 Introducing the Commands
27.4 Command Syntax Conventions
The rules of the commands are listed next.
• The command keywords are in courier new font.
• The required fields in a command are enclosed in angle brackets <>, for instance, ping
means that you must specify an IP number for this command.
• The optional fields in a command are enclosed in square brackets [], for instance,
configure snmp-server [contact ] [location
]
means that the contact and location fields are optional.
• “Command” refers to a command used in the command line interface (CI command).
• The | symbol means “or”.
• The entry
in the command lines refers to carriage return. Press [ENTER]
or carriage
return after a command to execute the command.
• Use the up (y) or down (z) arrow key to scroll through the command history list.
• The CLI does not accept partial or incomplete commands. You may enter a unique part of
a command and press
[TAB]
to have the switch automatically display the full command.
For example, if you enter “ config ” and press
[TAB]
, the full command of “ configure ”
automatically displays.
• Each interface refers to an Ethernet port on the switch. Commands configured after the
interface command correspond to those ports.
• Type multiple ports or port ranges separated by a comma. Ranges of port numbers are
typed separated by a dash.
27.5 Getting Help
The system includes a help facility to provide you with the following information about the
commands:
• List of available commands under a command group.
• Detailed descriptions of the commands.
27.5.1 List of Available Commands
Enter “ help ” to display a list of available commands and the corresponding sub commands.
Enter “ ? ” to display a list of commands you can use.