ZyXEL Communications ES-2108 - Manual (Page 192)

ES-2108 Series User’s Guide
192 Chapter 29 IEEE 802.1Q Tagged VLAN Commands
Figure 135 vlan1q port default vid Command Example
29.5.2 Set Acceptable Frame Type
Syntax:
frame-type
where
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports 1 to 5 to accept only tagged frames.
Figure 136 frame type Command Example
29.5.3 Enable or Disable Port GVRP
Use the gvrp command to enable GVRP on the port(s). Use the no gvrp command to disable
GVRP.
The following example turns off GVRP for ports 1 to 5.
Figure 137 no gvrp Command Example
29.5.4 Modify Static VLAN
Use the following commands in the config-vlan mode to configure the static VLAN table.
ras (config)# interface port-channel 1-5
ras (config-interface)# pvid 200
= Specifies all Ethernet frames (tagged and untagged) or only tagged
Ethernet frames.
ras (config)# interface port-channel 1-5
ras (config-interface)# frame-type tagged
ras (config)# interface port-channel 1-5
ras (config-interface)# no gvrp