ZyXEL Communications ES-2108 - Manual (Page 182)

ES-2108 Series User’s Guide
182 Chapter 28 Command Examples
An example is shown next.
• Enable port one for configuration.
• Enable broadcast control.
• Set the broadband packet traffic the interface receives per second.
Figure 120 broadcast-limit Command Example
28.10.3 bandwidth-limit
Syntax:
bandwidth-limit
bandwidth-limit egress
bandwidth-limit ingress
where
An example is shown next.
• Enable port one for configuration.
• Enable bandwidth control.
• Set the outgoing traffic bandwidth limit to 70Kbps.
• Set the incoming traffic bandwidth limit to 90Kbps.
Figure 121 bandwidth-limit Command Example
28.10.4 mirror
Syntax:
mirror
mirror dir
ras(config)# interface port-channel 1
ras(config-interface)# bmstorm-limit
ras(config-interface)# bmstorm-limit 21
Enables bandwidth control on the switch.
Sets the maximum bandwidth allowed for outgoing traffic (egress) or
incoming traffic (ingress) on the switch.
ras(config)# interface port-channel 1
ras(config-interface)# bandwidth-limit
ras(config-interface)# bandwidth-limit egress 70
ras(config-interface)# bandwidth-limit ingress 90