beautypg.com

Necessary items, Installation – Yamaha EX5R User Manual

Page 287

background image

7Turn over the EXIDO1 and place face down into the

support arms.

The EXIDO1 and the EXDGO is installed in the EX5R
upside down (with the board facing down). If
installed underside down, the output jack numbers
will not match the Individual Out settings.

8Slide the EXIDO1 towards the rear panel of the

EX5R and use the two screws removed in step

1 to

attach the board to the rear panel.

9Replace the EX5R top cover. See How to Replace the

EX5R Top Cover on page 285.

For information on Individual Output settings, see page
19.

MIDI

OUT

IN

INDIVIDUAL OUTPUT

6

5

4

3

DIGITAL OUTPUT

WORD CLOCK IN

AES EBU

INDIVIDUAL OUTPUT

2

1

OUTPUT

R

L MONO

Rear

Slide the board
in this direction.

Support arms

Turn over
the board.

Rear

How to Install the
EXDGO1

(Digital Output Board)

in the EX5R

Necessary Items

• EXDGO1 (Digital Output Board) x 1
• Flat cable x 1 (included in the EXDGO1 package)

Installation

You can install the EXDGO1 after removing the EX5R
top cover. For more information on removing the EX5R
top cover, see How to Remove the EX5R Top Cover.

When installing the optional board (from when you
remove the top cover to when the top cover is replaced
securely) all operations must be done with the power
cord disconnected.

The procedure for installing the EXDGO1 is the same
as for the EXIDO1. See How to Install the EXIDO1 in
the EX5R.
Only the points that are different from the EXIDO1
will be explained.

Same as the EXIDO1, the EXDGO1 is installed face down.

For information on Word Clock settings, see Utility mode
(page 277).

When the EXDGO1 is properly installed, L and R
signals will be output digitally.

When connecting the EXDGO1 (Digital Output AES/EBU
[XLR] jack) and an external audio device, use the XLR
cable with the impedance characteristics, 110

When receiving word clock from an external audio device,
you are required to connect the EXDGO1 (Word Clock In
[BNC] jack) and the external audio device. In this case, use
the BNC connector/coaxial cable with the impedance
characteristics, 75

287

Appendix

Option/E/qx 5/21/98 11:58 AM Page 287