Yamaha EX5R User Manual

Page 271

■

3 Arp MIDI A/B (Arpeggio MIDI A/B)

Sets whether or not the arpeggio data is output from
MIDI OUT A/B to an external device.

❏ Settings:

(output), (not

output)

MIDI B for the above two parameters is available only
with the EX5.

■

4 MIDI Trans Ch (MIDI Transmit Channel)

Sets which MIDI channel the operations on the
keyboard and/or controllers will be sent on.

❏ Settings: Ch1~Ch16

■

5 Arp MIDI Ch (Arpeggio MIDI Channel)

Sets which MIDI channel the arpeggio data will be
sent on.

❏ Settings: Ch1~Ch16

■ Kbd/TG Mode (Keyboard/Tone Generator

Mode)

Sets how the tone generator is connected in the
Voice mode. When used as a master keyboard, select
M.KBD (Master Keyboard). In general this is set to
TG (Tone Generator).

❏ Settings: M.KBD, TG

■ VelCurve (Velocity Curve)

Sets the velocity curve in the Voice mode. This
setting determines how the sound is produced
according to the strength at which notes are played
on the keyboard. To the right of the selected value,
the velocity curve is displayed graphically.

❏ Settings: norm (normal), soft, hard, wide, fix (fixed)

■ Vel Sens/Ofst (Velocity Sensitivity/Offset)

Sets the Velocity Sensitivity and Offset value.

❏ Settings:

Vel Sens (Velocity Sensitivity): 0~127
Vel Ofst (Velocity Offset): -64~0~+63

■ Controller Reset

Sets whether the controller value is retained (hold)
or initialized (reset) when a different voice is
selected. The controllers include Modulation Wheel,
After Touch, Foot Controller, Breath Controller,
Ribbon Controller (except EX5R), and Knobs.

❏ Settings: hold, reset

When “reset” is selected, the following controller
values will be reset to each default.

Pitch Bend: center

Modulation Wheel: minimum

After Touch: minimum

Foot Controller: maximum

Breath Controller: maximum

Ribbon Controller: center

Knobs1~6: center

[F2]: VOICE (Voice Mode Setup)

The Voice Mode Setup allows you to make settings for
the keyboard and controllers used in the Voice mode.
When the Voice Mode Setup is selected, [F7]:
CONNECT and [F8]: CTRL (Controller) sub-menus
will be displayed.

[F7]: CONNECT

Sets the signal flow how the keyboard and/or
controllers are connected to the internal tone generator
as well as other settings such as the velocity curve, for
the Voice mode.

■

1 Global Recv Ch (Global Receive Channel)

Sets the MIDI receive channel for the.

❏ Settings: Ch1~Ch16, omn (omni: all channels)

■

2 TrnsMIDI A/B (Transmit MIDI A/B)

Sets whether or not the operations on the keyboard
and/or controllers are output from MIDI OUT A/B
to an external device.

❏ Settings:

(output), (not

output)

2
3

271

Utility Mode

Utility4pdf/E/qx 3/15/99 8:47 PM Page 271