Yamaha EX5R - Manual (Page 276)

276
Utility Mode
Touch EG
You can express the portion “A” with the velocity and “B”
with the aftertouch.
■ Scene Controller Assign
Sets the controller for Scene Control. You can select
Modulation Wheel 2 or Foot Controller.
❏ Settings: MW2 (Modulation Wheel 2), FC (Foot
Controller)
For more information on Scene Control, see page 57.
■ Ribbon Controller Mode
Sets whether the Ribbon Controller value returns to
a center value when you release your finger from the
Ribbon Controller (reset), or the value is retained at
the value that your finger held before releasing
(hold).
❏ Settings: hold, reset
This parameter is not available with EX5R.
[F6]: OTHER (Other Setup)
The “Other” Setup allows you to make misllaneous
settings that are applied to the entire system.
■ Effect Bypass
Selects the type of effect that is by-passed (the effect
is not applied) when [EF BYPASS] ([BYPASS] on the
EX5R) is pressed on the front panel.
❏ Settings: Rev (Reverb), Cho (Chorus), Ins (Insertion) each
can be set to: ¨ (Off: effect is applied), ■ (On:
effect is by-passed)
0 A B
127
Breath
Control
Time
■ Memory Protect
Sets whether or not the current user Voice,
Performance, and Pattern data are protected. When
set to “on,” it is not possible to store data. This
setting is used on a temporary basis when you don’t
want to lose user data.
❏ Settings: on, off
■ Edit Confirm
Sets whether or not the “Are you sure?”
confirmation message will be displayed when you
execute a Job or store data. You may want to skip the
confirmation when you are accustomed to the EX
operations. When set to “on,” the message will be
displayed, and when set to “off,” the message will
not be displayed.
❏ Settings: on, off
■ SCSI ID
Sets the SCSI ID number for the EX. The EX’s SCSI
ID number is set to “2” when shipped from the
factory. When connecting the EX to a SCSI device
with the same SCSI ID number, it is necessary to
change one of the devices’ ID number.
This “SCSI ID” parameter is not displayed or selected
unless you install an optional ASIB1 SCSI Interface
board.
To connect an external SCSI device to the EX, it is first
necessary to install the separately sold ASIBI (SCSI
board).
When you change the SCSI ID number, it is necessary
for you to turn the power off and back to on again, to
make the change effective.
❏ Settings: 0~7
Utility/E/qx 5/21/98 11:55 AM Page 276