Yamaha EX5R - Manual (Page 256)

Arpeggio Mode
256
1. Quantize
This job quantizes note events over a specified range of
a designated track. You can use this feature, for
example, to correct the imperfect timing of a
performance you have recorded in real time.
For more information on functions and each parameter,
see page 212, Quantize in Song Job mode.
■ Track
❏ Settings: 1~4, all
■ Measure
❏ Settings: 01~16 (for the beginning measure and the end
measure)
■ Qunt (Quantize Value)
❏ Settings: , , , , , , , ,
■ Streng (Quantize Strength)
❏ Settings: 0%~100%
■ Sens (Quantize Sensitivity)
❏ Settings: –100%~+000%~+100%
■ Rate (Swing Rate)
❏ Settings:
When the quantize value is , , , :
50%~75%
When the quantize value is , , :
66%~83%
When the quantize value is or :
50%~66%
■ Vel (Swing Velocity)
❏ Settings: 0%~100%~200%
■ Gate (Swing Gate Time)
❏ Settings: 0%~100%~200%
2. Move Clock
This job shifts all event data for the specified range of
the designated arpeggio track by clock units. This job
will never move an event beyond the specified range’s
start or end point; any event that would otherwise
move beyond this point is instead deposited at the
beginning or end of the range.
For more information on functions and each parameter,
see page 214, Move Clock in Song Job mode.
■ Track
❏ Settings: 1~4
■ Measure
❏ Settings: 01~16 (for the beginning measure and the end
measure)
■ Clock
❏ Settings: –9999~+0~+9999
3. Modify GateTime
This job alters the gate time of the notes in the
specified range. The gate time indicates the length of
time that a note is held. For sustained voices, the gate
time is equal to the actual playback time span. You can
modify the gate time using two types of parameters: the
Rate and Offset.
For more information on functions and each parameter,
see page 215, Modify Gate Time in Song Job mode.
■ Track
❏ Settings: 1~4
Arpeggio/E/qx 5/21/98 11:51 AM Page 256