ZyXEL Communications ZyXEL Dimension ES-3124 - Manual (Page 256)

Dimension ES-3124 Ethernet Switch
32-4 IEEE 802.1Q Tagged VLAN Commands
Figure 32-4 garp status Command Example
32.4.4 Enable GVRP
Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the switch.
32.4.5 Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
32.5 Port VLAN Commands
You must configure the switch port VLAN settings in config-interface mode.
32.5.1 Set Port VID
Syntax:
pvid
where
= Specifies the VLAN number between 1 and 4094
This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.
Figure 32-5 vlan1q port default vid Command Example
32.5.2 Set Acceptable Frame Type
Syntax:
ras# show vlan1q gvrp
GVRP Support
---------------------
gvrpEnable = YES
ras(config)# interface port-channel 1-5
ras(config-interface)# pvid 200