ZyXEL Communications ZyXEL Dimension ES-3124 - Manual (Page 243)

Dimension ES-3124 Ethernet Switch
Command Examples 31-7
Use the boot config command to restart the switch and use a different configuration file (if specified). The
following example reboots the switch to use the second configuration file.
Figure 31-12 CLI: boot config Command Example
Use the reload config command to restart the system and use a different configuration file (if specified). The
following example restarts the system to use the second configuration file.
Figure 31-13 CLI: reload config Command Example
When you use the write memory command without specifying a configuration file index number,
the switch saves the changes to the configuration file the switch is currently using.
31.6.4 Resetting to the Factory Default
Follow the steps below to reset the switch back to the factory defaults.
1. Enter “ erase running config ” to reset the current running configuration.
2. Enter “ write memory ” to save the changes to the current configuration file. If you want to reset the
second configuration file, use the write memory command again with the specified index number.
The following example resets both configuration files to the factory default settings.
Figure 31-14 CLI: Reset to the Factory Default Example
31.7 Example no Commands
These are the commonly used command examples that belong to the “no” group of commands.
31.7.1 no mirror-port
Syntax:
no mirror-port
Disables port mirroring on the switch.
An example is shown next.
ras# boot config 2
ras# reload config 2
ras# erase running-config
ras# write memory
ras# write memory 2