Zhone Technologies 900 - Manual (Page 90)

3-2 IMACS System Release 5.1.6 Data Cards
Model No. Running Head OCU-DP Card Descriptions OCU-DP Card
3.2.1.2 Installing the OCU-DP 5 Card
Install the OCU-DP 5 Card in any user card slot. These slots are U1 to U8 on the two-sided
chassis and front-loading chassis with power supplies on top, and P1 to P4 or W1 to W4 on
the front-loading chassis with power supplies on the side.
3.2.2 OCU-DP 2 Card Description (8249)
The OCU-DP 2 Card has only two ports. Each card may be connected to a DSU/CSU
operating at one of the rates stated above for the OCU-DP 5 Card. In addition, the OCU-DP 2
supports BCH error correction, performance monitoring, and the CSU operating mode.
3.2.2.1 Card Jumpers/Switch Settings
The OCU-DP 2 Card does not have any jumpers or switches on its mainboard.
3.2.2.2 Installing the OCU-DP 2 Card
Install the OCU-DP 2 Card in any user card slot. These slots are U1 to U8 on the two-sided
chassis and front-loading chassis with power supplies on top, and P1 to P4 or W1 to W4 on
the front-loading chassis with power supplies on the side.
3.2.3 OCU-DP 10 Card Description (824660)
The OCU-DP 10 Card supports up to ten data ports operating at speeds up to 64 kbps
inclusive. This card interfaces directly with DSU/CSUs which can be located up to 4 miles
away.
3.2.3.1 Card Jumpers/Switch Settings
The OCU-DP 10 Card does not have any jumpers or switches on its mainboard.
3.2.3.2 Installing the Card
Install the OCU-DP 10 Card in any user card slot. These slots are U1 to U8 on the two-sided
chassis and front-loading chassis with power supplies on top, and P1 to P4 or W1 to W4 on
the front-loading chassis with power supplies on the side.