Zhone Technologies 900 - Manual (Page 81)

Data Cards IMACS System Release 5.1.6 2-15
SRU Card Test Screen
2.5 Test Screen
Pressing “t” (Test command) in the SRU Card Main Screen will bring up the Test Screen
shown in Figure 2-10. From this screen, you can create test situations between SRU cards, or
between a single card and data test equipment at a remote site.
Figure 2-10. Typical SRU Card Test Screen
The bottom highlighted line of the Test Screen shows some actions you can perform from this
screen. To perform an action, just press the uppercase key for the desired choice. Table 2-5
lists these actions, and Table 2-6 lists the settings in the Test Screen, along with their possible
and default values. These settings are also described in the following paragraphs.
Table 2-5. Test Screen Actions
Action Function
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Updates certain time-related information fields that are not automatically
updated (i.e., test status).
InsertErr Allows you to manually insert a single error into the clear data signal.
Clear Clears the Test Screen and resets all counters to zero.