Zhone Technologies 900 - Manual (Page 43)

Data Cards IMACS System Release 5.1.6 1-31
HSU Card HSU Card User Screens and Settings
Once the appropriate information is inserted or changed on the fields of this screen, you can
place a call by pressing “D” (Dial) command from the Call Profile screen. When finished, the
call can be disconnected by pressing “H” (Hangup) command from the Call Profile screen.
It is important to note that the HSU port used to dial the call must be in the standby
(stdby) state when the call is placed. The state changes from standby to active after the call
has been placed. The system will not allow a call to be placed from an active port.
Note: Any changes made to the loaded call profile will stay with the call profile copy until
changed in a future session. Changes made to this copy will not change the call profile
template on the Interface card.
Figure 1-17. HSU Card Call Profile Screen
Table 1-11. HSU Card Call Profile Screen Actions
Action Function
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Updates certain time-related information fields that are not automatically
updated (i.e. performance and test data).
Dial Causes the HSU port to dial the number on the original call profile or the
changed call profile.
Bcast Provides access to the Broadcast screen. Se the Broadcast section later in
this chapter.