USRobotics V.34 - Manual (Page 34)

COURIER HIGH SPEED MODEMS
Internal Modem Set Up 3-
3. Unscrew the solid bracket at the back of any available
standard half-card slot.)
The bracket will pop out of the back, leaving an opening in
DIP switches.
4.
and a 2-inch groove. These grooves are lined on both sides
with metal guides. Insert the modem board into the slot
modem board's edge connector firmly in the 3-inch groove.
Figure 3.3  Inserting the Modem
Screw the vertical bracket at the back of the modem firmly
to the computer's rear panel, as shown in Figure 3.3. This
and keeps the modem board firmly in place.
6.