USRobotics V.34 - Manual (Page 156)

COURIER HIGH SPEED MODEMS
D-14 Remote Access
When you make remote configuration changes, the remote
prompt is altered to indicate that changes have been made. The
prompt will change from:
Remote->
to
Remote+>
If you restore the original configuration (with %C1, explained
next), the original prompt is also restored (back to Remote->),
indicating that the original configuration is intact.
By default, configuration changes do not take effect until the
connection is terminated (see %C
n). However, the new configu-
ration is immediately reflected on the information screens
(ATI
n).
Remote Configuration Commands
There are some additional commands that are only executable
during a remote access session. These commands are as
follows.
%B n Configure the Courier's serial port rate.
%B0 110 bps %B6 9600 bps
%B1 300 bps %B7 19,200 bps
%B2 600 bps %B8 38,400 bps
%B3 1200 bps %B9 57,600 bps
%B4 2400 bps %B10 115,200 bps
%B5 4800 bps
%C n Configuration control.
%C0 Defer configuration. This is the default. Configu-
ration changes are deferred until the call is ended;
they take effect for ensuing connections. You do
not need to enter this command; it is the default
unless you enter %C1 or %C2.