beautypg.com

USRobotics V.34 User Manual

Page 109

background image

COURIER HIGH SPEED MODEMS

Summaries and Tables B-15

S-REGISTER SUMMARY

USAGE

The default values are those users typically require. Change the
settings of an S-Register with the ATS

r=n command, where r is

the register and

n is a decimal value from 0-255:

ATS13=8

The modem does not perform a value-range check. Some
values you select may not work with some equipment, and
you'll have to readjust the settings.

Some registers (S13, S14, S15, S16, S27, S34) are bit-mapped (bits
0-7). For example, turning on bit 0 of S13 causes the modem to
reset each time the computer or terminal drops its Data
Terminal Ready (DTR) signal. Turning on bit 3 of S13 causes
the modem, on receipt of DTR, to auto dial the number stored at
position 0 in NVRAM.

To turn on one or more bits in any bit-mapped register, use the
total of the values shown below. For example, S13=9 turns on
bits 0 (value of 1) and 3 (value of 8).

Alternatively, identify the bits to be turned on with the
following format: S

r.b=1, where r is the register and .b is the bit.

This format does not require knowledge of the bit's value.
S13.0=1 .3=1 is the equivalent of S13=9, above. To turn off a bit
function, set it to zero: S13.0=0.

To display the contents of a register, use ATS

r? as in this

example:

ATS19?