beautypg.com

USRobotics V.34 User Manual

Page 184

background image

COURIER HIGH SPEED MODEMS

G-2 Additional Operations

CELLULAR OPERATIONS

This function applies to Dual Standard HSTs only. HST cellular
modems can be used to answer or originate calls, but are
proprietary. They can only connect with other U.S. Robotics
Dual Standard modems with HST cellular capabilities.

To enable cellular mode, load the &F3 template settings by
typing the following command:

AT &F3

To save this as your power-on/default setting, type this:

AT &F3 &W

The &F3 command sets the serial port rate to 19,200 bps, and
formats the data for 8 bits, no parity and one stop bit. The ini-
tialization string sent to the modem by loading this template is
shown below.

AT B1 X7 S10 = 30 &B1 &L2 &H1 &I0 &R2

B1

enables HST modulation

X7—displays extended result codes including NO DIAL
TONE, RINGING, NO ANSWER, and BUSY messages

&B1

locks the serial port rate so that it remains higher

than the connection rate.

S10=30

sets the modem to wait 3 seconds after loss of

carrier before hanging up.

&L2

enables cellular mode

&H1

enables hardware flow control

&I0

disables software flow control

&R2

sets the modem so it sends received data to the

computer or terminal when the Ready To Send (RTS)
signal is high, only if the computer or terminal supports
RTS.