USRobotics V.34 - Manual (Page 151)

COURIER HIGH SPEED MODEMS
Dial Security D-9
Then assign the password as your autopass password.
Enter the following command, where
n is the number of the
account you set up):
AT %V=PWn
You can check to see that you've correctly set up your
autopass password by typing the following command:
AT I10
Your autopass password appears in the right-hand column
below FORCED AUTOPASS.
Once the autopass password is set, enable your Courier
modem’s Dial Security with the following command:
ATS53.0=1 &W
3. If Dialback is enabled at the host Courier site, set your
modem to answer the host modem when it disconnects and
dials back.
To set the modem to answer the Dialback call, set DIP
switch 5 OFF and reset the modem (ATZ ).
Alternatively, type the following command:
AT S0=1
4. Call the host modem.
5. When the call is completed, if you want to disable auto
answer, do one of the following:
• Set DIP switch 5 ON and reset the modem
(ATZ).
• Type the following command:
AT S0=0