USRobotics V.34 - Manual (Page 33)

COURIER HIGH SPEED MODEMS
3-6 Internal Modem Set Up
Set DIP Switches
A ten-position bank of Dual In-Line Package (DIP) switches is
located at the rear of the modem. A summary of the DIP switch
functions and options is in Appendix B in this manual and on
the Quick Reference Card.
WARNING: Check your software documentation for its
requirements, particularly for DIP switches 1, 4, 5 and 6.
NOTE: Once the modem is installed, the DIP switches are
accessible through the computer's rear panel.
INSTALLING THE MODEM
1. Turn off the computer and peripheral devices.
2. Remove the computer's cover. Refer to the computer man-
ual, if necessary, to see which rear panel screws to remove
before sliding the cover off.
NOTE: Our illustration shows expansion slots lined up ver-
tically on the floor of the computer. Some computers are
configured so that the expansion slots are stacked horizon-
tally, one on top of another. The following instructions
apply for both configurations.
Figure 3.2   Removing the Computer Cover