Renesas M16C FAMILY - Manual (Page 47)

4 Using the FoUSB
2) When pressing the "Select MCU" button, the screen shown in Figure 4-21 is
displayed. Select the Target MCU in this screen.
First, select the category of the Target MCU to be used form the MCU Category
Column (M16C/26 Group is selected from M16C/Tiny Series in Figure 4-21). Next,
select the Target MCU to be used from the MCU Select Column. If the MCU which is
indicated by highlight is duble-click or button is clicked, the confirmation
screen will be displayed.
MCU Select Column MCU Category Column
Figure 4-21 Chip Selection screen
3) Click the button, if the confirmation screen is displayed, and download the
firmware to USB Monitor Board.
Figure 4-22 Confirmation screen
4) The screen shown in Figure 4-23 is displayed while the system is downloading the
firmware to USB Monitor Board.
Figure 4-23 Firmware Download screen
44