Renesas M16C FAMILY - Manual (Page 12)

2 Product Specifications
2. Product Specifications
2.1 FoUSB (Flash-over-USB)
FoUSB is the software that allows you to operate on M16C, M32C, R8C or 740
microcomputers with built-in flash memory from a Windows version host computer
(Windows 98SE or later).
2.2 KD30/KD3083
The KD included with the package is the debug software that runs on a Windows version
host computer. This KD is usable for only the R8C/Tiny, M16C/10, M16C/20, M16C/Tiny,
M16C/60, M16C/80 or M32C/80 series of Renesas 16-bit and 32-bit single-chip
microcomputers with built-in flash memory. The KD provides a powerful debugging
environment. In addition, it is operationally compatible with and can therefore be used the
same way as PD30 (or PD308F), the emulator control debugger for Renesas 16C/62
microcomputers. The features of the Remote Debugger are outlined below. For details,
see Section “5. Using the KD”.
Table 2-1 PD30 and KD30 comparison
No. Item PD30 KD30
1 Software break function 64 points 2 points to 8 points (Note)
2 Hardware break function 6 points not included
3 RAM monitor function included included
4 Real time trace included not included
5 Time measurement function included not included
6 Script function included included
Note: Software break numbers are dependent on the address match circuit numbers are
built-in MCU.
9