Roland ATELIER AT-300 - Manual (Page 94)

92
Record and Playback Your Performance
Caution
If you press the [Rec] button when a song has been selected
from the USB memory or floppy disk, the selected song will be
completely loaded into the ATELIER and the Composer will
enter into the recording standby mode. To record a new song,
use the following procedure.
ig.07-12-2.eps
1. Press the [Rec] button to cancel recording
standby.
2. Disconnect the external media.
If you’ve connected USB memory, disconnect the USB
memory from the external memory connector. If you’re
using a floppy disk, remove the floppy disk from the disk
drive.
3. Delete the performance data (p. 94).
Re-record your performance.
f
If the following screen appears
fig.E-30.eps
When recording was automatically canceled because
the memory limit was reached.
Here’s how to play back a performance you’ve recorded.
fig.08-06
1. Press the [Reset] button.
The location at which playback will start will return to the
beginning of the first measure (bar).
If you wish to begin playback from the middle of the
song, press the [Bwd] button or [Fwd] button to move to
the measure from which you wish to begin playback.
2. Press the [Play/Stop] button to start playback.
After playback reaches the end of the performance, it
will stop automatically.
3. To stop playback at any point, press the [Play/
Stop] button.
The [Play/Stop] function can be assigned to the foot switch
(p. 69).
You can specify whether or not the Expression Pedal will
affect the playback and what you play while Atelier music
data is being played back (p. 107).
If you use the Rhythm or Automatic Accompaniment
immediately after having loaded and played back a song
other than an Atelier performance song, such as SMF’s, etc.,
the playback may not sound right (the voices may have
changed, etc.) To prevent this from happening, press the
[Reset] button before playback.
Playing Back a Performance
Song
1 2,3
NOTE
AT-100-300_e.book 92 ページ ２００８年５月７日 水曜日 午後３時３３分