Roland ATELIER AT-300 User Manual
Page 102
100
Record and Playback Your Performance
4.
Press the Value [-] or [+] button to select the
SMF music files that you wish to load into
internal memory.
5.
Press the [Load] button.
The selected performance data will be loaded into
internal memory.
6.
Press the [Bwd] button and the [Fwd] buttons
to select the desired measure (bar) when you
start recording.
If you wish to start recording from the beginning of the
song, press the [Reset] button.
7.
Select the panel settings needed for recording
the performance.
8.
Press the [Rec] button to enter recording-
standby mode.
The [Rec] button indicator will light, and the [Play/Stop]
button and the unrecorded track buttons will blink. The
track buttons that are already recorded will light.
9.
Press the button of the track you want to
record, so it’s blinking.
The existing performance data in the specified track will
be erased as recording takes place.
When the button for a track lights steadily, it means it won’t
be recorded.
10.
Press the [Play/Stop] button to start recording.
During recording, the performance data that was loaded
into the ATELIER will play back.
11.
Press [Stop] button to stop recording.
The track button for which performance data has been
recorded will be lit.
The performance data you recorded can be saved on a USB
memory, “Favorites,” or floppy disk (p. 96).
Commercially sold music files can also be loaded into the
ATELIER, but for reasons of copyright protection, cannot be
saved in SMF format.
The performances of Channel 2 in SMF music files are
deleted when pedal performances are recorded over again.
1.
Prepare the performance data whose tempo
you want to change.
If you’re using performance data from USB memory,
connect it to the external memory connector.
If you’re using performance data from a floppy disk,
connect the floppy disk drive to the external memory
connector, and insert the floppy disk.
2.
Load the performance data into the ATELIER
.
3.
Determine the tempo with the Tempo [
] and
[
] buttons.
4.
Hold down the panel [Reset] button and press
the [Rec] button.
The tempo of the performance data will change.
NOTE
NOTE
NOTE
Using Song with a Different Tempo
Than That of the Performance Song
3
6
4
3
AT-100-300_e.book 100 ページ ２００８年５月７日 水曜日 午後３時３３分