Troubleshooting – Roland ATELIER AT-300 User Manual
Page 127
125
Troubleshooting
Appendices
Troubleshooting
If the ATELIER does not function in the way you except, first check the following chart. If this does not
resolve the problem, consult your dealer or a nearby Roland Service Station.
Problem
Check
Solution
Page
When you press the [Power On]
switch, the power doesn’t come on
Power cord is not connected correctly.
Connect the power cord correctly.
Nothing appears on screen
The ATELIER uses a liquid-crystal
screen, so text may not be displayed
when the ambient temperature is
below freezing.
This is not a malfunction.
- - -
It appears as though there are
vertical stripes in the screen
This is due to the nature of a liquid
crystal display, and is not a
malfunction.
This is not a malfunction.
- - -
The device connected to the Input
jack is not loud enough
Could you be using a connection cable
that contains a resistor?
Use a connection cable that does not
contain a resistor.
- - -
The volume level of the instrument
connected to ATELIER is too low.
Could you be using a connection cable
that contains a resistor?
Use a connection cable that does not
contain a resistor.
Can’t read/write USB memory
Could you be using USB memory not
made by Roland?
We cannot guarantee operation if
you’re using USB memory not made by
Roland.
- - -
Noise is heard in the sound
If there is a cell phone nearby, you
may hear noise from the ATELIER when
an incoming call or outgoing call
occurs, or during a conversation.
Keep the cell phone as far away as
possible, or turn off its power.
- - -
No sound is heard
The [Master Volume] knob is set too
low.
Turn the [Master Volume] knob toward
“Max.”
Headphones are connected.
When you connect the headphones,
the sound is heard only through the
headphones.
If you want sound to be output from the
speakers, disconnect the headphones.
The plug is still plugged into the
headphone jack.
Disconnect the plug from the
headphone jack.
The volume is set too low on the Level
[
▲
] or [
▼
] button.
Press the Level [
▲
] or [
▼
] button to
raise the volume.
The volume is set too low on the
Expression Pedal.
Advance the expression pedal.
You do not have a Voice selected.
Voices that have their button indicator
lit can be played.
Press a voice button to select a voice.
No sound is heard
(by the Lower keyboard)
Drums/SFX are selected for the Lower
keyboard, but you are playing a key to
which no drum sound is assigned.
Turn the Drums/SFX off or play keys to
which drums sounds are assigned.
No sound is heard (when external
devices are connected)
The power of the connected external
devices is not turned on.
Use the correct procedure to turn on
the power of the connected external
devices.
AT-100-300_e.book 125 ページ ２００８年５月７日 水曜日 午後３時３３分