Roland ATELIER AT-300 - Manual (Page 60)

58
Using the Registration Buttons
When the [Manual] button is ON (lit), all panel settings you make will be
stored automatically in the [Manual] button as they are made, thus updating
the Registration that had been previously saved. If you change to a preset
Registration [1]– [8] button, it is possible to return to the previous panel
settings by pressing the [Manual] button.
fig.07-03
When saving Registration sets, names like “Factory Reg.” will be assigned by
default, but you can assign a name that will help you later to identify the
contents of the Registration set.
fig.07-03
1.
Press the [Display/Exit] button a number of times to access
the registration screen.
Automatically Registering When You Switch Panel Settings
Assigning a Name to a Registration Set
Write 2 3 4 1 Manual
NOTE
The settings stored in the
[Manual] button returns to the
default settings while the power
is turned off.
2,4 2,4
3
3 1
AT-100-300_e.book 58 ページ ２００８年５月７日 水曜日 午後３時３３分