Roland ATELIER AT-300 - Manual (Page 120)

118
Various Other Settings
The V-LINK function is turned on, and the V-LINK icon
appears in the main screen.
fig.09-41.eps
The Send PC Switch settings is automatically switched to
ON when V-LINK is on (MODE 1, MODE 2). When the V-
LINK function is switched off, the Send PC Switch setting
reverts to the setting in effect before V-LINK was switched
on.
For more on switching video images, refer to the owner’s
manual for the connected device.
When V-LINK is set to “MODE 1”
When a Registration button is pressed, “Bank Select”
and “Program Change Number” messages are
transmitted from the MIDI Out connector as video
control messages. At this time, the Control MIDI
transmit channel setting is disregarded, and the
messages are transmitted via Channel 16.
When V-LINK is set to “MODE 2”
In addition to the functions of “MODE 1,” MODE 2
also sets the device to transmit “Note messages” as
video control messages from the MIDI Out connector
when one of the twelve rightmost keys in the Lower
keyboard is pressed.
In this case, the Lower and Solo MIDI transmit channel
settings are disregarded, and the messages are
transmitted via Channel 16.
The MIDI transmit channel used for video control
messages is fixed at channel 16.
NOTE
You can also use the following procedure to turn the
V-LINK function on.
1. Hold down the [Reset] button and press
either the Upper [Full] button or the Upper
[Brass] button.
Holding down the [Reset] button and pressing the
Upper [Full] button switches the instrument to
“MODE 1” (p. 117). Holding down the [Reset]
button and pressing the Upper [Brass] button
switches the instrument to “MODE 2” (p. 117).
The display changes as shown below, and the
ATELIER switches to Image Control mode.
fig.09-42.eps
The V-LINK function is turned on, and the V-LINK
icon appears in the main screen.
fig.09-41.eps
2. To cancel the V-LINK function, once again
hold down the [Reset] button and press
either the Upper [Full] button or the Upper
[Brass] button.
If set to “MODE 1” (p. 117), holding down the
[Reset] button and pressing the Upper [Full] button
switches the V-LINK function off. If set to “MODE
2” (p. 117), holding down the [Reset] button and
pressing the Upper [Brass] button switches the V-
LINK function off.
1,2
AT-100-300_e.book 118 ページ ２００８年５月７日 水曜日 午後３時３３分