Roland ATELIER AT-300 - Manual (Page 93)

91
Record and Playback Your Performance
Record and Playback Your Performance
The indicators for Track button in which performances were
recorded will be lit. By turning off these Track button
indicators, you can temporarily silence the sound. This is
referred to as “Track Mute.”
If you want to play back a song from USB memory, connect
your USB memory to the external memory connector before
you continue.
If you want to play back a song from floppy disk, connect your
floppy disk drive to the external memory connector, and insert
the floppy disk.
1. Press the Track button whose indicator is lit to
turn the light off.
The track whose indicator was turned off will be muted
(silenced).
2. Press the Track button once again (indicator
lights).
The part that had been muted will return to normal and
will be heard.
Assignments to the Track Button When
Playing Back Commercial SMF Music Files
You can also change the Track Mute Settings in the Utility
menu (p. 113). You can individually mute the rhythm track
and accompaniment track as well as the Upper Track and
Solo Track. You can also mute the Control Track (for the
expression pedal and panel controls) (p. 113).
You can record the performance that you play. You can also
record your performance while playing rhythms or automatic
accompaniment.
fig.07-12.eps
1. Select the panel settings needed for recording
the performance.
2. Enter the recording standby mode by pressing
the [Rec] button.
The [Rec] button indicator will light, and the [Play/Stop]
button will blink.
3. Press the [Play/Stop] button to start recording.
When you press [Play/Stop] button, the metronome will
sound a two-measure count, and then recording will
begin.
If you wish to use Rhythm and Automatic Accompaniment as
you record, press the [Start/Stop] button (p. 42) instead of
the [Play/Stop] button to begin recording. Also, if the
Synchro Start is ON, recording will begin the instant you
play the Lower keyboard.
4. Press the [Play/Stop] button when you have
completed your recording.
The Track indicator where a performance song is
recorded will light.
When you press the [Intro/Ending] button or [Start/Stop]
button while recording a Rhythm performance or
Automatic Accompaniment, the Rhythm performance
and Automatic Accompaniment will stop. However, the
recording itself will continue. Press the [Play/Stop]
button to stop recording.
The Play and Stop functions can both be assigned to one of
the foot switches located on each side of the Expression
Pedal (p. 69).
Silencing a Specific Track
(Track Mute)
Button Channel
[Bass] 2
[Lower] 3
[Solo/Upper] 1, 4
Recording a Performance
2 3, 4
AT-100-300_e.book 91 ページ ２００８年５月７日 水曜日 午後３時３３分