RGB Spectrum Quadra User's Guide - Manual (Page 67)

C O M M A N D L I N E I N T E R F A C E
Command Summary
350-7951 Quadra User’s Guide 59
.
. .
.
.
I N P U T C O M M A N D S D E S C R I P T I O N S
The table below lists all input commands, their arguments and detailed
descriptions.
Table 4-3. Input Commands Descriptions
Command Arguments Description
INputAutoSync [ON | OFF
| DEBUG] Sets the input mode for the specified input. ON
enables the autosync circuitry. OFF disables the
autosync circuitry.
When Autosync is enabled ( ON ), the current WSR
settings are automatically reset to full size when the
input signal is re-synchronized.
When Autosync is disabled ( OFF ), the WSR
settings are retained even with a loss of the input
signal.
Debug provides information on input status and
reports changes to measured parameters.
Default: ON
INputFormat Checks the video format of the current video input
selection. The command is only valid when
INputSouRCe is set to Composite or S-Video.
The response to the command will be NTSC or
PAL.
INputINTeractive Enters input interactive mode to visually adjust
specified input’s timing parameters. A white box
appears over the full screen input.
Starting with the upper-left corner of the image, use
these keyboard controls to position the image within
your display raster:
i = move up j = move left
m = move down l = move right
With the upper-left corner properly adjusted,
address the lower-right corner next by using these
keyboard controls:
I = move up J = move left
M = move down L = move right
With the image properly adjusted, quit the utility:
q = quit
After you have adjusted the input to your
satisfaction, use the
INputNAME command to
name your input source, and the INputSAVE
command to store the setting to the Input List.