Nortel Networks 1000ASE-XD - Manual (Page 201)

201
Using the BayStack 420 10/100/1000 Switch
Appendix E
Default settings
Table 56 lists the factory default settings for the BayStack 420 Switch according
to the console interface (CI) screens and fields for the settings.
Table 56 Factory default settings
Field Default setting Appears in this CI screen
BootP Request Mode BootP Disabled “IP Configuration/Setup screen” on
page 94
In-Band Stack IP Address 0.0.0.0
(no IP address assigned)
In-Band Switch IP Address 0.0.0.0
(no IP address assigned)
In-Band Subnet Mask 0.0.0.0
(no subnet mask assigned)
Default Gateway 0.0.0.0
(no IP address assigned)
Read-Only Community String public “SNMP Configuration screen” on
page 99
Read-Write Community String private
Trap IP Address 0.0.0.0
(no IP address assigned)
Community String Zero-length string
Authentication Trap Enabled
Link Up/Down Trap Enabled
sysContact Zero-length string “System Characteristics screen” on
page 100
sysName Zero-length string
sysLocation Zero-length string