High speed flow control configuration screen – Nortel Networks 1000ASE-XD User Manual
Page 131
Chapter 3 Using the console interface
131
Using the BayStack 420 10/100/1000 Switch
High Speed Flow Control Configuration screen
The High Speed Flow Control Configuration screen (
) allows you to set
the port parameters for the Gigabit Ethernet Interface.
Choose High Speed Flow Control Configuration (or press h) from the Switch
Configuration Menu screen to open the High Speed Flow Control Configuration
screen.
LnkTrap
Allows you to control whether link up/link down traps are sent to the configured trap
sink from the switch.
Default Value
On
Range
On, Off
Autonegotiation
When enabled, sets the corresponding port speed to match the best service provided
by the connected station, up to 100 Mb/s in full-duplex mode. This field is disabled for
all fiber optic ports.
Default Value
Enabled
Range
Enabled, Disabled
Speed/Duplex
1
Allows you to manually configure any port to support an Ethernet speed of 10 Mb/s
or 100 Mb/s, in half- or full-duplex mode. This field is set (by default) to 1000 Mb/s,
full-duplex for Gigabit ports only.
Default Value
100Mbs/Half (when Autonegotiation is Disabled)
Range
10Mbs/Half, 10Mbs/Full, 100Mbs/Half, 100Mbs/Full
1 Fiber optic ports can only be set to 100 Mb/s/Half or 100 Mb/s Full.
Note: The GBIC module does not need to be installed to configure the
port.
Table 24 Port Configuration screen fields (continued)
Field
Description