Nortel Networks 1000ASE-XD - Manual (Page 115)

Chapter 3 Using the console interface 115
Using the BayStack 420 10/100/1000 Switch
Figure 51 MAC Address Security Port Lists screen
Table 18 describes the MAC Address Security Port Lists screen fields.
Port list syntax
When you enter a port list in a stack configuration, you must specify either a unit/
port list, NONE, or ALL. In a stack configuration, ALL indicates all of the stack
port; whereas, in a standalone scenario, ALL indicates all of the switch ports.
Table 18 MAC Address Security Port Lists screen fields
Field Description
Entry This field indicates the port list number (S1 to S32) that corresponds to the
values you set in the Port List field.
Port List This field allows you to create a port list that you can use as an “Allowed
Source” in the MAC Address Security Table screen.
Note: NONE and ALL must be entered in uppercase characters as
shown in the screen prompt.