Nortel Networks 1000ASE-XD - Manual (Page 129)

Chapter 3 Using the console interface 129
Using the BayStack 420 10/100/1000 Switch
Port Configuration screen
The Port Configuration screen (Figures 58 and 59 ) allows you to configure
specific switch ports or all switch ports. You can enable or disable the port status
of specified switch ports, set the switch ports to autonegotiate for the highest
available speed of the connected station, or set the speed for selected switch ports
(autonegotiation is not supported on fiber optic ports).
You can disable switch ports that are trunk members; however, the screen prompts
for verification of the request before completing the action. Choosing [Yes]
disables the port and removes it from the trunk.
To open the Port Configuration screen:
Figure 58 Port Configuration screen (1 of 2)
Note: The Autonegotiation fields, the Speed fields, and the Duplex
fields are independent of MultiLink Trunking, VLANs, and the STP.
Choose Port Configuration (or press p) from the Switch Configuration Menu
screen.