Nortel Networks 1000ASE-XD - Manual (Page 171)

Chapter 3 Using the console interface 171
Using the BayStack 420 10/100/1000 Switch
Table 40 describes the Configuration File Download/Upload screen fields.
Table 40 Configuration File Download/Upload screen fields
Field Description
Configuration Image
Filename The file name you have chosen for the configuration file. Choose a
meaningful file name that will allow you to identify the file for retrieval when
required. The file must already exist on your TFTP server and must be read/
write enabled.
Default Value Zero-length string
Range An ASCII string of up to 30 printable characters
TFTP Server IP Address The IP address of your TFTP load host.
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal
point
Copy Configuration
Image to Server Specifies whether to copy the presently configured switch/stack parameters to
the specified TFTP server (default is No).
Use the spacebar to toggle the selection to Yes.
Press [Enter] to initiate the process.
Default Value No
Range Yes, No
Retrieve Configuration
Image from Server Specifies whether to retrieve the stored switch/stack configuration parameters
from the specified TFTP server (default is No). If you choose Yes, the
download process begins immediately and, when completed, causes the
switch/stack to reset with the new configuration parameters.
Use the spacebar to toggle the selection to Yes.
Press [Enter] to initiate the process.
Default Value No
Range Yes, No