NETGEAR ProSafe WNDAP330 - Manual (Page 94)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
4-2 Advanced Configuration
v1.0, May 2008
.
3. Configure the following TCP/IP configurations for using the WNDAP330 as a DHCP Server
for wireless clients.
• DHCP Server: By default, the Dynamic Host Configuration Protocol (DHCP) server is
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless
access point will get its IP address, subnet mask and default gateway settings
automatically from the DHCP server on your network when you connect the WNDAP330
to your LAN.
• Starting IP Address: Enter the starting IP address that can be assigned from the DHCP
server on this Access Point.
• Ending IP Address: Enter the Ending IP address that can be assigned from the DHCP
server on this Access Point
• Subnet Mask: The Access Point will assign the specified subnet mask to the connected
wireless stations.
Figure 4-1