NETGEAR ProSafe WNDAP330 - Manual (Page 111)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
Advanced Configuration 4-19
v1.0, May 2008
• If using DHCP, all WNDAP330 Wireless Access Points should be set to “Obtain an IP
address automatically (DHCP Client)” in the IP Address Source portion of the Basic IP
Settings menu.
• All WNDAP330 Wireless Access Points use the same SSID, Channel, authentication
mode, if any, and encryption in use.
4. Verify connectivity across the LANs.
A computer on any LAN segment should be able to connect to the Internet or share files and
printers with any other PCs or servers connected to any of the three WLAN segments.
5. Click Apply to save your settings.
Note: You can extend repeating by adding up to two additional WNDAP330s configured
in repeater mode. However, since Repeater configurations communicate in half-
duplex mode, the bandwidth decreases as you add Repeaters to the network. Also,
you can extend the range of the wireless network with NETGEAR wireless antenna
accessories.