NETGEAR ProSafe WNDAP330 - Manual (Page 74)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
3-4 Management
v1.0, May 2008
• Baud rate: 9600 bps
• Data bits: 8
• Parity: none
• Stop bit: 1
• Flow control: none
These settings appear below the connector on the back panel.
3. Press Enter. The screen shown below in Figure 3-3 should appear.
4. Enter the login name and password (admin and password are the defaults).
After successful login, the <Access Point Name> prompt should appear. In this example, the
prompt is netgear74F35E.
5. Enter help to display the CLI command help.
CLI Commands
The CLI commands are listed in Appendix C, “Command Line Reference .”
Figure 3-3