NETGEAR ProSafe WNDAP330 - Manual (Page 59)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
Basic Installation and Configuration 2-33
v1.0, May 2008
To configure a Security Profile:
1. From your Web browser, log in to the WNDAP330 using the default LAN address of
http://192.168.0.230, user name admin and password password, or use the LAN address and
password that you set up.
2. Under the Configuration tab, select Security from the main menu, and then select either
Security Profile Settings for 802.11b/g/n or 802.11a/n. The screen for the Profile Settings you
selected will display as shown in
Figure 2-16 above.
3. Check the radio button of the profile you want to modify and click Edit. The Security Profile
Configuration screen for the selected profile will display.
4. Give your profile a meaningful name so that you can remember it later.
5. The Wireless Network Name (SSID) is set by default to identify it as NETGEAR-11a.
6. Enable or disable the Broadcast Wireless Network Name (SSID). It is enabled by default. (If it
is broadcast, it can be easily detected by other clients.)
7. From the pull-down menu shown in Figure 2-16 , select the Network Authentication Type you
want to use for this profile:
Figure 2-16