NETGEAR ProSafe WNDAP330 - Manual (Page 73)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
Management 3-3
v1.0, May 2008
Using the Secure Telnet Interface
The WNDAP330 includes a secure Telnet command line interface (CLI). You can access the CLI
from a secure Telnet client over the Ethernet port or over the serial console port.
To use the CLI from a Console Port:
1. Using the null-modem cable, connect a VT100/ANSI terminal or a workstation to the port
labeled Console.
If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure terminal-
emulation program.
2. Configure the terminal-emulation program to use the following settings:
Figure 3-2
Note: You must use a secure Telnet client such as Absolute Telnet. Also, when you
configure the client, use the SSH1, 3DES option. If you use the Telnet client to
connect over the Ethernet port, use the IP address of the WNDAP330 as the host
name.