Paradyne ACCULINK 317x E1 - Manual (Page 94)

Configuration Options
C-7 3170-A2-GB20-20 December 1996
Network Interface
Configuration Options
Table C-3
Network Interface Configuration Options
NET Frame: noCRC
Next CRC4 noCRC Prev
Network Line Framing Format. Designates the framing format for the Network E1 interface.
CRC4 – Configures for the CRC4 framing format.
noCRC – Configures for the non-CRC4 framing format.
Mgmt Link: Disab
Next Disab SNMP Prev
FDL Management Link. Specifies whether Facility Data Link (FDL) is enabled. Selecting SNMP allows SNMP
management traffic to flow over the 4 kbps data link provided by FDL. Running SNMP over FDL requires an end-to-end
FDL connection and cannot be terminated within the network.
Disab – Disables the FDL Management Link.
SNMP – Enables the FDL Management Link for SNMP.
NOTE: This configuration option is not available and does not appear if EDL is enabled for SNMP.
NOTE: If the local E1 DSU/CSU’s FDL is enabled for SNMP, the remote E1 DSU/CSU’s FDL must also be enabled for
SNMP.
Circuit Ident:
Next Edit Clear Prev
Network Circuit Identifier. Specifies the transmission vendor’s circuit identifier for the purpose of facilitating
troubleshooting. The network circuit identifier is an ASCII text string that may be up to 255 characters in length.
Edit – Allows you to edit and/or display the network circuit identifier using the generic text string entry screen.
Clear – Allows you to clear the network circuit identifier. The network circuit identifier will be set to a null string.