Paradyne ACCULINK 317x E1 - Manual (Page 51)

Operation
3-29 3170-A2-GB20-20 December 1996
7. Select the desired port by pressing its
corresponding Function key.
F1
Channel Config:
Prt1
Prt2 Prt3
F2 F3
8. The configuration option for the data port channel
allocation destination appears on the screen. Select
NET to assign this port to the Network E1
interface, select DTE to assign this port to the
DTE Drop/Insert interface, or press the
key
and the appropriate Function key to assign this
port to another port.
F1
Assign To:NET
Next
NET DTE
F2 F3
9. Press F1 (Next) to display the appropriate
configuration options on the screen. Use one of
the following examples, depending on whether
you are assigning by block or individual channel.
Block Channel Assignment Method
The Assign By configuration option screen appears
after you select a port.
To assign by the block method,
1. Press F2 (Block).
F1
Assign By:
Next Block
Chan
F2 F3
2. Press F1 (Next) to display the next configuration
option (Port Rate).
F1
Assign By:Block
Next Block
Chan
F2 F3
3. Use the or key to scroll the desired port
rate onto the screen. Rates scroll in groups of
three. Available selections depend on the current
base rate selected for the port. Press the
corresponding Function key to select the port rate.
Then, select Next to display the Start At
configuration option on the screen.
F1
Port Rate:384
Next
64 128
F2 F3
4. The Start At screen displays the configuration
option used to select the starting DS0 channel. If
the destination selected is the Network E1
interface, then the Network channels appear on the
screen. If the destination selected is the DTE
Drop/Insert interface, then these channels appear
on the screen.
The following screen shows an example of the
Network E1 interface. Use the
or key to
scroll the desired channel onto the screen. Use the
Function keys to select the starting channel. Only
those DS0 channel numbers that provide enough
bandwidth (based on the configured data rate) to
be used as a starting channel number are
displayed. Channel allocation for this port can
only be cleared by selecting Clear.
F1
Start At:Clear
Next
Clear N1
F2 F3