Philips HDR3700 - Manual (Page 9)

9 EN
1 ANTENNA IN
• Connect to an antenna or a cable.
2 TV-OUT
• Connect to the Aerial jack on your TV, cable box
or direct broadcast system to output the signal
received. Use the supplied RF cable.
3 AUDIO OUT (ANALOG L \R) jacks
• Connect to the audio input jacks on your TV.
Use a commercially available Audio cable.
4 AUDIO OUT (DIGITAL COAXIAL) jack
• Connect to an amplifier with a digital input jack
such as a Dolby Digital decoder or MPEG
decoder. Use a commercially available Coaxial
cable.
5 COMPONENT VIDEO OUTPUT jacks
• Connect to the component video input jacks on
your TV. Use a commercially available
Component Video cable.
6 AV2 (AUX) socket
• Connect to VCR, camcorder, or other Audio-
Video equipment (Cable Box, Satellite Receiver,
etc). Use a commercially available Scart cable.
7 HDMI OUT jack
• Connect to a display with an HDMI compatible
port. Use a commercially available HDMI cable.
8 AV1 (TO TV) socket
• Connect to the Scart socket on your TV. Use the
supplied Scart cable.
9 Mains cable
• Connect to a standard AC outlet.
Note
• Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage
to the unit.
• After turning off the unit, leave the mains cable plugged for about one minute.
Otherwise it may cause the data loss or the unit may not work properly.
• This unit does not have an RF modulator.
Rear Panel
1 2 5 3 4 7 9 6 8
In
tr
od
uct
ion
Con
n
ec
ti
on
s
Ini
tial
Setu
p
P
layb
ack
Edi
tin
g
O
thers
General Settings
Recording
E2N41BN_EN.book Page 9 Wednesday, July 2, 2008 4:36 PM