Palm TX - Manual (Page 26)

Palm ® T|X Handheld 4
CHAPTER 1 Setting Up Your Handheld and Your Computer
Step 1: Connecting and charging your handheld
0
1
Connect your handheld:
a. Plug the USB sync cable into
your handheld and into a USB
port on the back of your
computer.
b. Plug the AC charger into the
Multi-connector on the sync
cable and into an outlet.
2
Charge your handheld for three hours. Be sure your handheld is fully charged
before going on to Step 2.
Done
Before You Begin [ ! ]
If you’re upgrading from
another Palm Powered™
device, synchronize your
old handheld with your
old desktop software.
Tip
On a laptop computer, the
USB port may be located
on the side.
Tip
After the initial charge,
charge your handheld
at least half an hour
every day.