Pioneer RM V2550BU - Manual (Page 57)

47
INSTALLATION AND ASSEMBLY
[Fig. 3-4-10]
[10] Block the holes on the cabinets (on the surfaces that become the outer panels of the system) using light
insulating stickers. [Fig. 3-4-11]
Light insulating stickers x 10 (provided with cabinets)
[9] Attach the screen frame support brackets onto the bottoms of the cabinets using screws. [Fig. 3-4-10]
Screen frame support brackets x 4 (provided with screen frames)
Screws (4 dia. x 16) x 8 (provided with screen frames)
[Fig. 3-4-11]
7 Procedure when the system is installed up against the rear wall
[11] When the system is to be installed up against the rear wall, perform the procedure till step [10] above while
the system is apart from the rear wall, then complete the rear wiring.
[12] Check the operations including those of the power supply.
[13] After ensuring that there is no problem in operation, release the adjusters of the stands temporarily and
approach the entire system to the wall by moving it slowly and cautiously.
[14] After moving the system to the installation location, secure the adjusters of the stands.
(Side panel) 2 holes per surface
Light insulating sticker
(Top panel) 1 hole per surface
Side of cabinet
Screen frame support brackets
Holes to be used (x 2 on left and right)
NOTE) To prevent hazard, never mount on a cabinet.