Pioneer RM V2550BU - Manual (Page 172)

162
MVP MANUAL
(3) To store the picture frame data [&W command]
Input : &W0, &W1
Explanation : &W0 : Sets the saved values to the settings at shipment.
(Load data using the &L command.)
&W1 : Saves the value adjusted.
• The parameters saved by the &W command are as follows.
• Picture frame data (Data changed by the &G command.)
• Screen start position data (Data changed by the &P2 command and &Q2 command.)
• Note : When this command is executed, the setting will be saved even if the power is turned off.
Therefore, all precious settings will be erased.
(4) To load the picture frame data [&L command]
Input : &L0, &L1
Explanation : &L0 : Loads the picture frame data set at shipment on the RAM.
&L1 : Loads the picture frame data saved at the end on the RAM. (Data when power is turned on)
• The parameters loaded by the &L command are as follows.
• Picture frame data (Data changed by the &G command.)
• Screen start position data (Data changed by the &P2 command and &Q2 command.)
• Use this command to reference the adjustment data temporarily.